PM to Lay Foundation for 2.8 GW Mahi Banswara Nuclear Plant
POWER & RENEWABLE ENERGY

PM to Lay Foundation for 2.8 GW Mahi Banswara Nuclear Plant

The foundation stone for the 2,800 MWe Mahi Banswara nuclear power plant in Rajasthan will be laid next week by Prime Minister Narendra Modi, marking the entry of state-owned NTPC, one of India’s largest integrated power companies, into the nuclear energy sector. The project is a joint venture between Nuclear Power Corporation of India Limited (NPCIL) and NTPC Limited, with NTPC holding a 49 per cent stake.
The plant will feature four indigenous pressurised heavy water reactors (PHWRs) of 700 MWe each, spread over slightly more than 1,300 acres on the right bank of the Mahi river, upstream of the Mahi Bajaj Sagar dam. The project, safeguarded by the International Atomic Energy Agency (IAEA), is estimated to cost Rs 420 billion.
Once operational, it will become Rajasthan’s second nuclear power facility, following the 2,580 MWe Rajasthan Atomic Power Project (RAPP) at Rawatbhata, where seven of eight units with 1,880 MWe installed capacity have already been commissioned, and an eighth 700 MWe unit is under construction.
A senior official from the Ministry of Power stated that the Mahi Banswara project will take approximately six and a half years to complete. On NTPC’s nuclear foray, the official noted, “NTPC believes in sustainability…Nuclear is the future of energy. With our energy demand growing, renewable sources alone are insufficient to meet requirements.”
India’s current nuclear capacity stands at 8,180 MW, a fraction of the 229,715 MW total power demand recorded in August, according to National Load Despatch Centre data. The government has set an ambitious target of achieving 100 GW nuclear capacity by 2047.
Currently, NPCIL operates all 24 commercial nuclear reactors in India, including two Boiling Water Reactors (BWRs), 20 PHWRs—including a 100 MW PHWR in Rajasthan—and two 1,000 MW VVER reactors. The government plans to increase nuclear capacity to 22,480 MW by 2031-32 through the construction and commissioning of ten reactors totalling 8,000 MW across Gujarat, Rajasthan, Tamil Nadu, Haryana, Karnataka, and Madhya Pradesh, with pre-project work underway for ten additional reactors.
India has also granted in-principle approval for a 6 x 1,208 MW nuclear plant at Kovvada in Andhra Pradesh’s Srikakulam district, in cooperation with the United States.
Finance Minister Nirmala Sitharaman highlighted the importance of nuclear energy in the 2025-26 budget, announcing the Nuclear Energy Mission to enhance domestic capabilities, encourage private sector participation, and accelerate deployment of advanced nuclear technologies, including Small Modular Reactors.

The foundation stone for the 2,800 MWe Mahi Banswara nuclear power plant in Rajasthan will be laid next week by Prime Minister Narendra Modi, marking the entry of state-owned NTPC, one of India’s largest integrated power companies, into the nuclear energy sector. The project is a joint venture between Nuclear Power Corporation of India Limited (NPCIL) and NTPC Limited, with NTPC holding a 49 per cent stake.The plant will feature four indigenous pressurised heavy water reactors (PHWRs) of 700 MWe each, spread over slightly more than 1,300 acres on the right bank of the Mahi river, upstream of the Mahi Bajaj Sagar dam. The project, safeguarded by the International Atomic Energy Agency (IAEA), is estimated to cost Rs 420 billion.Once operational, it will become Rajasthan’s second nuclear power facility, following the 2,580 MWe Rajasthan Atomic Power Project (RAPP) at Rawatbhata, where seven of eight units with 1,880 MWe installed capacity have already been commissioned, and an eighth 700 MWe unit is under construction.A senior official from the Ministry of Power stated that the Mahi Banswara project will take approximately six and a half years to complete. On NTPC’s nuclear foray, the official noted, “NTPC believes in sustainability…Nuclear is the future of energy. With our energy demand growing, renewable sources alone are insufficient to meet requirements.”India’s current nuclear capacity stands at 8,180 MW, a fraction of the 229,715 MW total power demand recorded in August, according to National Load Despatch Centre data. The government has set an ambitious target of achieving 100 GW nuclear capacity by 2047.Currently, NPCIL operates all 24 commercial nuclear reactors in India, including two Boiling Water Reactors (BWRs), 20 PHWRs—including a 100 MW PHWR in Rajasthan—and two 1,000 MW VVER reactors. The government plans to increase nuclear capacity to 22,480 MW by 2031-32 through the construction and commissioning of ten reactors totalling 8,000 MW across Gujarat, Rajasthan, Tamil Nadu, Haryana, Karnataka, and Madhya Pradesh, with pre-project work underway for ten additional reactors.India has also granted in-principle approval for a 6 x 1,208 MW nuclear plant at Kovvada in Andhra Pradesh’s Srikakulam district, in cooperation with the United States.Finance Minister Nirmala Sitharaman highlighted the importance of nuclear energy in the 2025-26 budget, announcing the Nuclear Energy Mission to enhance domestic capabilities, encourage private sector participation, and accelerate deployment of advanced nuclear technologies, including Small Modular Reactors.

Related Stories

Gold Stories

Next Story
Infrastructure Urban

KONE Opens India's First Digital Experience Centre in Pune

KONE, a global elevator and escalator manufacturer, has inaugurated its first Digital Experience Centre (DEC) in India, located in Pune. The facility aims to showcase how artificial intelligence (AI), connectivity and data-driven technologies can enhance customer experiences and improve building operations.The centre was inaugurated by Jussi Herlin, Executive Vice Chair, KONE Corporation; Philippe Delorme, President and CEO, KONE; and Nandan Nilekani, Co-founder and Chairman of the Board, Infosys.Designed as an interactive customer environment, the facility demonstrates digital solutions cover..

Next Story
Infrastructure Urban

CII GreenCo Launches Circularity Guidelines for Indian Industry

The Confederation of Indian Industry (CII) GreenCo Council has launched the CII GreenCo Circularity Guidelines – Pilot Version at the 17th CII GreenCo Waste & Resource Management Summit 2026 in Chennai. The initiative aims to strengthen resource efficiency, waste reduction and circular economy practices across Indian manufacturing and process industries.The guidelines introduce a structured framework with circularity indices covering raw materials, consumables, packaging and other resource inputs. These indicators will help industries assess existing practices, identify opportunities to ..

Next Story
Infrastructure Energy

Global Electronics Association Launches IPC-1783-CO2E Standard

The Global Electronics Association has introduced IPC-1783-CO2E, a new international standard aimed at improving consistency, transparency and comparability in product carbon footprint reporting across the electronics manufacturing industry.The standard, titled International Standard for Data Collection and Reporting of CO2 Equivalent (CO2e) Emissions for the Electronics Manufacturing Supply Chain, provides industry-specific guidance for collecting, estimating and reporting carbon emissions data.With increasing regulatory requirements and customer expectations, electronics manufacturers face c..

Advertisement

Subscribe to Our Newsletter

Get daily newsletters around different themes from Construction world.

STAY CONNECTED

Advertisement

SPECIAL OFFER
QR Code